Spine Techline and Ortho Techline Options |
|
Cat. No. |
Description |
Sugg. List price |
|
FAS |
Film activated micro switch |
30.00 per panel |
|
CS |
Cluster switch |
Standard |
|
MS |
Master switch |
25.00 per unit |
|
HGP |
Hospital grade plug |
20.00 per unit |
|
SFG-36 |
Side film clip (left side only) |
Standard |
|
SFG-51 |
Side film clip (left side only) |
Standard |
|
Spine and Ortho-Techline Re-Mount Retrofit Kits: |
|
Re-Mount SURFACE Kit (to change fixture from surface mount to recess mount): |
40.00 per panel for 14x36" units
50.00 per panel for 14x51" units |
|
Re-Mount RECESS Kit (to change fixture from recess to surface mount): |
65.00 per panel for 14x36" units
75.00 per panel for 14x51" units |
Spine and Ortho Techline Specifications
ELECTRICAL
110-124 Volt 60 Hz:
SPINE-TECHLINE 200 SERIES..........0.67 Amps per panel
SPINE-TECHLINE 400 SERIES..........1.34 Amps per panel
ORTHO-TECHLINE 200 SERIES.........0.73 Amps per panel
ORTHO-TECHLINE 400 SERIES.........1.46 Amps per panel
All SPINE-TECHLINE fixtures are U.L. & CSA listed.
All ORTHO-TECHLINE fixtures are U.L. & CSA listed.
Grounded chassis with 3-wire 7-ft. Cord and NEMA 5-15, 2-pole, 3-wire grounded plug.
No hazardous electrical parts are exposed when the diffusing panel is removed for lamp replacement.
LAMPS:
General Electric: #F30T12/D or equivalent (for SPINE-TECHLINE fixtures)
General Electric: #F40T12/D or equivalent (for ORTHO-TECHLINE fixtures)
BALLAST:
MAXANT's ballast has premium features as follows:
Rapid start ballast which does not require an external starter
U.L. and CSA approved
Thermal protected-the ballast will disconnect from the powerline in the event of excess heat
Low leakage
Self start reliability in excess of 10,000 cycles
Anticipated 50,000 hours operating life
Suppression of conducted radio frequency transmission into power lines
CONSTRUCTION: Each unit is welded steel construction. Multi-panel units are manufactured as an integral assembly.
FILM GRIP: Roller gravity film holding system accommodates all film thickness variations. Will not scratch or tear film. Requires no field adjustment. Open sides facilitate the viewing of oversize film.
DIFFUSING PANEL: 1/8" shatter resistant, U.L. listed, translucent thermoplastic
SWITCHES: A two-position rocker switch, which provides ON/OFF lighting to each panel, is standard. The optional film activated switch has three position rocker switch which provides manual ON/OFF and FILM ACTIVATED LIGHTING which activates when a film is inserted into the film grip.
The optional master switch for multi-panel units is a two position rocker switch which provides a master ON/OFF for the entire unit.
Cluster switching is standard on multi-panel units. The switches are centrally located at the bottom of the fixture, configured in the same layout as the viewing panels they control.
|
14X51"
